|
Carefully examine all hydraulic hoses and fittings at common intervals
to be sure airworthiness. Investigate any fluid loss or symptoms of
leakage. Check the metallic pipe leaks, free anchor, scratches, kinks
or other harm. Inspect the fittings and connections for leakage,
looseness, cracks, burrs or other hurt. Exchange or restore faulty
products. Ensure that that hoses usually are not chewing on each other
and are appropriately secured, and clamped.
a. Substitute metal pipe. When checking the hydraulic hoses to get
broken or broken, exchange your entire line or, in the event the
harmed area of a area, repairs could be entered. Replacing air hose,
normally make use of a tube of uniform dimensions and material because
the principal line. Use the old pipe as being a template for the new
tube bending, unless of course he's also corrupt, then the template is
usually produced of tender iron wire. Delicate aluminum tubing (1100,
3003 and 5052), lower than 50 % an inch outdoors diameter is often bent
by hand. For all other use acceptable into the tubes by hand or
electrical pipe-bending instrument. Bending tubing very carefully in
order to avoid extreme straightening of kinking or wrinkling. A little
volume of flattening of the curve is appropriate, but need to not exceed
seventy five percent on the initial outer diameter. Too much
flattening will induce fatigue failure of hydraulic pipe. Putting in
alternative pipe line it effectively with the mating piece is he is
not pressured into alignment according to tighten nuts.
b. Hose couplings and pipe joints. Quite a few pipe connections are
created with flared ends from the tube
Typical communications gear: -818 (MS 20818) and nut-819 (MS 20819)
sleeves. The choice of rockets, the pipe ends sq. cut, the situation
is easy, take out all burrs and sharp edges, and extensively cleaned.
Tubes are then flared using the proper 37-degree flare-making program
Aviation tubing plus the style and measurement on the installation.
Dual lighting is applied on gentle aluminum tubing 3/8-inch outer
diameter and below, along with a worsening of every one of the other
pipes. To the connections that use hydraulic fluid as being a lubricant,
and tighten. Overtightening harm the pipe or fitting, which could bring
about failure. Under-tightening may well trigger leakage, which could
guide to program failure.
JET
708675PK Table Saw »
Powermatic 1792013K Table Saw »
Shop
Fox W1819 Table Saw »
DELTA 36
982 Table Saw »
Hitachi C10RA3 Table Saw »
|
ผู้สนับสนุนเรา
